Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) PowerPack & Stinger-Plus systems (connects to pump wire) - Manual (Page 16)

amount of the grease into the
connector and install the connector
onto the wire identified in step 39 as
shown in Figure 11.
42.
Locate the Manifold Absolute
Pressure (MAP) sensor on the
intake manifold. Unplug the factory
connector, and plug the corresponding
connectors on the OttoMind wire loom
into the sensor and the factory wire
loom. See Figure 12.
43.
Plug the corresponding male
bullet connector on the wire loom to
the installed connector on the pump.
44.
Remove three Phillips-head
screws from the trim panel below the
steering column and remove panel by
pulling directly toward the rear of the
vehicle. Toward the right side of the
opening, remove two Phillips-head
screws and install the OttoMind as
shown in Figure 13.
45.
Plug the main connector from
the wire loom into the OttoMind
connector. Route all wiring away
from any pedals or other moving
components. Using the cable ties
supplied, secure the wiring under the
dash. Reinstall the trim panel. Secure
all wiring under the hood away from
heat sources or sharp edges. For
manual transmissions the BLUE wire
will be unused and may be cable tied
out of the way.
46.
Remove the forward bolt on the
fuel filter mounting bracket. Install the
ring terminal of the ground wire under
the head of the bolt and reinstall the
bolt. See Figure 12.
Figure 9
16
96397 v.8.0