Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) PowerPack & Stinger-Plus systems (connects to pump wire) - Manual (Page 17)

47.
Locate the gray Throttle Position
Sensor (TPS) connector just above
the injection pump. Unplug the
connector and plug both ends into
the corresponding connectors on the
OttoMind wire loom. See Figure 12.
Note: For manual transmission
applications, proceed to Step 53.
48.
On automatic transmission
models, locate the PCM (rectangular
metal box with three connectors
mounted on the passenger’s
side of the firewall) in the engine
compartment. See Figure 14.
49.
Make sure that the ignition is off,
then disconnect all three connectors
from the PCM for easier accessibility
to the wires.
50.
Select the center (white) connector
and locate the wire in the No.11
connector pin cavity. This will typically
be an ORANGE wire with a BLACK
Figure 10
96397 v.8.0
17