Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) PowerPack & Stinger-Plus systems (connects to pump wire) - Manual (Page 9)

9.
Drill through the exhaust manifold
into the rear passage at the location
shown in Figure 4. Use a 7 ⁄
16
” drill,
keeping the drill perpendicular to the
manifold surface.
10.
Tap the drilled hole with a 1 ⁄
4
”
NPT pipe tap. Check the thread
depth as you tap by periodically
removing the tap and screwing the
thermocouple into the tapped hole.
The thermocouple should thread in 3
Figure 4
96397 v.8.0
9