Tools required – Banks Power Dodge Trucks: (Diesel ’98 - 02 5.9L Cummins ISB) PowerPack & Stinger-Plus systems (connects to pump wire) User Manual
Page 3
Tools Required:
These tools are necessary for all
levels of installation unless otherwise
specified.
•
1
⁄
4
” and
3
⁄
8
” drive ratchets with inch
and metric sockets including
5
⁄
16
”,
7
⁄
16
” deep
1
⁄
4
” drive sockets and a
1
⁄
4
”
drive extension
• Inch and metric combination or
open-end wrenches
• Standard and Phillips head
screwdrivers
• Standard and needle-nose pliers
• Pocket or X-Acto knife
• Clean shop towels or rags
• Drill motor
• Tap handle
•
1
⁄
8
” Allen wrench
•
3
⁄
16
” and
7
⁄
16
” drill bits
•
1
⁄
4
” NPT tap
• Heat gun (suggested) or cigarette
lighter
• Pry bar or large groove-joint (water
pump) pliers
• Wire crimping/stripping tool
• Oxy-acetylene torch or reciprocating
saw
Highly recommended tools and
supplies (not applicable to all system
levels):
• Inch-pound and foot-pound torque
wrenches
• Inline fuel pressure test check valve
fittings
• Fuel pressure test gauge
• Compressed air source and hose
• Air pressure regulator
• Rubber tipped air blow gun
• Multimeter or 12-volt test light
• Penetrating oil or light lubricant
spray
96397 v.8.0
3