Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1204 User Manual
Page 17
12
PNEG-1204 Enclosed Belt Conveyors
Conveyor Assembly
1. Fasten covers to the belt conveyor with the
3/8" easy grip handles provided. Adequately
tighten the 3/8" handles so that the covers
are in tight contact with conveyor cross
channels.
2. When a loader is on the conveyor, the cover
section may have to be cut accordingly to
accommodate the loader. For installation of
a loader, see Loader Installation on page 13.
3. Conveyor covers are made to fit over the
entire width and half the length of a conveyor
intermediate section. Standard covers mea-
sure approximately 4' 7" in length. When a
loader is ordered, the cover may be mea-
sured and cut to take up the displacement of
the loader housing. This depends on the
position of the loader.
COVER INSTALLATION
Standard Cover Length
Easy Grip
Handles
3/8" Wing
Nut on Tail
Section to
Secure
Cover.
DO NOT Walk on Conveyor Covers!
4' 7"