Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1204 - Manual (Page 42)

37 PNEG-1204 Enclosed Belt Conveyors
Troubleshooting
Conveying belt drifts
sideways.
Material buildup on
idler pulley, drive pulley
or between sections
and belt.
Lack of capacity.
Belt not properly tracked.
Belt splice not square.
Material not placed on
center of belt.
Machine is not straight.
Machine not level.
Material buildup on
pulleys.
Material getting under
belt.
Loader not being used.
Conveying belt slippage.
Track belt over pulleys.
Check splice squareness, re-splice.
Direct material through loader and
spouting.
Check machine alignment with chalk
line or string.
Check and level sections.
Clean pulleys, retrack belt.
Remove buildup from pulleys and
sections.
Track conveying belt.
Check machine alignment and
levelness.
Eliminate point(s) where material may
be entering under belt.
Use loader to position material on
center of belt. All material must be
directed through hopper.
Tighten so belt conforms to crowned
pulleys.
27, 28, 29
21
30, 31, 32
9, 10, 27
27
--
SYMPTOM PROBLEM SOLUTION PAGE
TROUBLESHOOTING
--
27,28, 29
9, 10, 27
--
--
35