Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1204 - Manual (Page 26)

21 PNEG-1204 Enclosed Belt Conveyors
Belting Assembly
INSTALLATION OF BELT
1. Hand thread the belt through the conveyor
with the tail section in a retracted position.
Attach a tightening device to each end of the
belt to prevent damage to the belt. Place a
2" x 12" piece of wood width wise on top of
an intermediate section where the belt ends
are to be brought together. Bring the belt
seam together over the 2" x 12" piece of
wood for a working surface to be used for
splicing. (See diagram below.) The belt
splice can now be installed following step-by-
step directions on the following four pages.
2" x 12" Block of Wood
Conveyor
Belt Ends
Intermediate Section with Covers Removed
Install Flippers on end belt
that has been pre-punched
and cut by factory.
Field cut, square, and
punch holes in field
this end of belt.
DIRECTION OF BELT TRAVEL
Factory Supplied Splice
Protector (Flipper)
HEAD
END
TAIL
END
Detail installation of belting into conveyor.
Install belting into tail end.
IMPORTANT: Note the direction of the flippers on belt.
Flippers are installed to aid in cleanout of tail shroud.