Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1204 User Manual
Page 29
Advertising
24
PNEG-1204 Enclosed Belt Conveyors
Belting Assembly
7. Start nuts on bolts by hand.
8. Cut Flexco-Lok Tape 3-1/2 times the belt
width and feed tape under top plates, under
the bottom plates, then back under top
plates.
9. Pull tape tight and hold in position by tighten-
ing a fastener at each end. Then tighten all
other plates.
10. Tighten all nuts uniformly. NOTE: A flexco
Power Wrench used with an impact tool will
speed this step considerably.
SPLICING THE BELT
(Cont.)
7
8
9
10
Advertising