Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1204 - Manual (Page 30)

25 PNEG-1204 Enclosed Belt Conveyors
Belting Assembly
11. Hammer plates in belt with wood block.
Retighten nuts.
12. Break off excess bolt ends using two bolt
breakers. Peen or grind bolts to finish.
13. Place flippers on belt. The flipper should be
located so the tail of the flipper covers the
splice. Note direction of belt travel. The
flippers are evenly spaced across the belt
with a 1/4" gap between them. There will be a
larger gap between the outside flipper and
the edge of the belt.
14. Punch or bore holes. Attach flippers using
same connectors as splice. Repeat steps
10-12.
15. Finished splice.
11
12
SPLICING THE BELT (Cont.)
13
Direction of
Rotation