Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1204 - Manual (Page 21)

16 PNEG-1204 Enclosed Belt Conveyors
Motor Assembly
Torque Arm Turnbuckle Assembly
6. Install the torque arm between the 2 plates
that are located on the bottom of the reducer
drive. Secure using bolt with washer and lock
nuts. Attach the other end to the torque arm
bracket on the conveyor using two bolts,
washers, and locknuts. Tighten the torque arm
by turning the turnbuckle. Adjust the position
of the reducer. The reducer should be in a
vertical position as shown on page 14.
7. The torque arm bracket is mounted under the
first intermediate section. Locate bracket by
matching an existing set of holes in the
intermediate side that allows the turnbuckle
assembly to be as short as possible with the
reducer in a vertical position.
MOTOR AND TORQUE ARM II
REDUCER INSTALLATION
(CONT.)
Torque Arm Bracket
Plates on
Reducer Drive
Torque Arm
Torque
Arm
Bracket
Torque Arm
Torque
Arm
Bracket
Torque Arm
Assembly
Plates
on
Reducer
Drive
Turnbuckle
Turnbuckle
The holes in the intermediate side must
be drilled out to 9/16" Diameter. Attach
with provided hardware.