Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1204 User Manual
Page 40
Advertising
35
PNEG-1204 Enclosed Belt Conveyors
Start-Up
SECURE SHROUD DURING MAINTENANCE
1. Check for and remove any tools or debris
that may have been left in the conveyor
during installation.
2. Tighten the take-up rods on the tail section
equally. The belt should be tightened suffi-
ciently to prevent slippage between the drive
pulley and belt and to conform to the crown
on the crowned head pulley.
3. Install covers after belt has been trained.
While accessing the tail pulley, the tail shroud
may either be removed or pivoted in an upright
position. If pivoted upright, then secure the
shroud by placing the chain in the slot as shown.
Chain
Slot
Shroud
STARTING CONVEYOR
Advertising