Grain Systems PNEG-1743 - Manual (Page 17)

4. Boot Screen
PNEG-1743 Vision for Tower Dryers 17
Select the “Scan Network” button. This scan will check the dryer to make sure all parts of the control
system are communicating directly.
6. After the scan is complete, the Display I/O, Main I/O, Moisture Control and the Fan/Heater(s) should
be shown as “Nothing to Report”. (See Figure 4F.)
Figure 4F
Touch the “Exit” button.
7. Choose the “Select Program” button from the “Boot Loader” screen. (See Figure 4G.)
Figure 4G
NOTE: A Display I/O, Main I/O,
Moisture Control and one entry for
each Fan/Heater on the dryer
should appear.