Grain Systems PNEG-1743 - Manual (Page 42)

42 PNEG-1743 Vision for Tower Dryers
7. Initial Settings Check
Dealer Suggested Initial Settings Check
1. Power on using the Control Power switch. Wait approximately 30 seconds.
2. Now viewing the “Boot Screen”, select “Start Dryer”.
3. Setup timers.
4. Using the “Extended Setup Screen”, select the following options to configure the dryer. Please use
Operations Chapter on Page 19 as a reference guide.
a. “Dryer Model” and check and verify the following parameters:
• Number of Fans
• Fuel
• Model Number
b. Set date and time settings.
c. Set temp scale settings.
d. Set data logger settings.
5. Using the “Setup Screen”, select the following options to configure the dryer. Please use Operations
Chapter on Page 19 as a reference guide.
a. Set unload parameters settings.
b. Check burner mode settings.
c. Moisture control setup. (Refer to Moisture Control Options Chapter on Page 35 for detailed
operation descriptions.)
Owner Suggested Initial Settings Check
1. Power on using the Control Power switch. Wait approximately 30 seconds.
2. Now viewing the “Boot Screen”, select “Start Dryer”.
3. Using the “Setup Screen”, select the following options to configure the dryer. Please use
Operations Chapter on Page 19 as a reference guide.
a. Set drying mode settings.
b. Select moisture control setup. (Refer to Moisture Control Options Chapter on Page 35 for detailed
operation descriptions.)
4. Set switches appropriately on the control panel.
5. Select the “Start” button on the control panel.