Grain Systems Unload Augers PNEG-1430 - Manual (Page 15)

4. Assembly
PNEG-1430 6"-6", 6"-8", 8"-8", 8"-10" and 10"-12" 25° Bin Unloader 15
Installing the Motor Mount Plate
1. Secure one of the motor mount adjustment nuts and one of the motor mount adjustment washers
approximately 3/4" of the way down the motor mount adjuster’s threaded shaft.
2. Once the nut and washer are secure, slip the motor mount plate over the adjuster and align the pivot
holes with the pivot tube. (See Figure 4F.)
Figure 4F
3. Slide the motor mount pivot rod through the pivot tube on the discharge tube.
4. When the pivot rod begins to extend through the pivot tube, install the spacers BETWEEN the back
plate and the inner face of the motor mount plate. (See Figure 4G.)
Figure 4G
5. Secure pivot rod with two (2) 3/16" x 2" cotter pins.
NOTE: The number of spacers will vary depending on size of unloader.