Grain Systems Unload Augers PNEG-1430 - Manual (Page 25)

PNEG-1430 6"-6", 6"-8", 8"-8", 8"-10" and 10"-12" 25° Bin Unloader 25
9. Maintenance
Maintain the Auger
A. Use caution when repairing or replacing equipment parts.
B. Make sure ALL decals are legible and tightly attached to the auger. If necessary, replace them FREE
OF CHARGE by contacting your dealer or the manufacturer.
C. Ensure that ALL electric motors, etc., are operating at the proper speed.
D. Maintain proper adjustments on the belt(s).
E. Mount controls for any electric motors at a safe distance from the machine and in a location
accessible in case of an emergency.
F. Make sure ALL electrical wiring is not damaged and that it meets proper wiring codes.
G. Make sure ALL components are in good working condition before use.
H. Check the auger flighting to make sure it is in good working condition.
I. Check the internal bearing bracket, bearing and universal joint to make sure they are in good
working condition.
J. Grease bearing at least two (2) times each season.
DANGER
ALWAYS shut down and disconnect the power supply before adjusting,
servicing or cleaning the equipment.