Start-up, Chapter 6 start-up, Perform pre-start checks – Grain Systems Unload Augers PNEG-1430 User Manual
Page 21
PNEG-1430 6"-6", 6"-8", 8"-8", 8"-10" and 10"-12" 25° Bin Unloader
21
6. Start-Up
Perform Pre-Start Checks
A. Make sure ALL belts are tensioned properly.
B. Make sure ALL shields are in place and that the belt(s) and pulley(s) are able to move freely.
C. Inspect the drive unit for any problems or potential problems.
D. Be aware of any emergency shut down procedures. Two (2) people must always be in a position
where the operation of the equipment can be monitored.
E. Before starting the auger for the first time, make sure that all parts are assembled correctly according
to the instructions in this manual.
DANGER
Failure to perform any or all of these pre-start checks may cause damage to the
equipment and/or cause SERIOUS INJURY or DEATH to those in the work area.
Failure to perform any or all of these pre-start checks may also be a misuse of the
equipment. Any misuse of the equipment may void the warranty.
ALWAYS keep ALL guards and shields in place, until all the power is
disconnected and locked out.
DANGER
WARNING
Make certain ONLY trained operators are in the work area before operating or
moving the machine. Two (2) people must always be in a position where the
operation of the equipment can be monitored.