Grain Systems Unload Augers PNEG-1430 - Manual (Page 19)

4. Assembly
PNEG-1430 6"-6", 6"-8", 8"-8", 8"-10" and 10"-12" 25° Bin Unloader 19
Installing the Belt Guard
1. With the belts properly tensioned, remove the bottom belt guard cover and slip belt guard down over
motor shaft.
2. Bolt the belt guard to the belt guard mounting brackets. Note that the brackets should still be loose
at this time.
3. Align the motor shaft and the flight drive shaft in the belt guard’s slot, making sure that the belt guard
DOES NOT contact either pulley or shaft and tighten down the belt guard mounting brackets to the
bearing plate.
(See Figure 4K.)
4. Once the brackets are tightened, slide the bottom cover back into place and secure with supplied bolt.
Figure 4K