Grain Systems Unload Augers PNEG-1430 - Manual (Page 18)

4. Assembly
18 PNEG-1430 6"-6", 6"-8", 8"-8", 8"-10" and 10"-12" 25° Bin Unloader
Installing the Motor (Not Provided)
1. Attach the motor to the motor mount plate using appropriate bolts, lock washers and hex nuts.
(See Motor Bolt Chart below.)
2. Install pulley onto motor shaft making sure that it is aligned with the flight pulley. It may be necessary
to move spacers to gain shaft alignment. (See Figure 4J.)
Figure 4J
Installing the Belts
1. Place the belts on the pulleys.
2. Screw the lower motor mount adjustment nut upward, thereby raising the motor mount plate and
putting tension on the belts.
3. Once the desired tension is reached, tighten the upper motor mount adjustment nut down onto the
motor mount plate to lock it into place. (See Figure 4K on Page 19.)
Motor Bolt Chart
Motor Size Hex Bolt Size Qty
56
5/16"-18 x 1-1/4" 4 143T
145T
182T
3/8"- 16 x 1-1/4" 4
184T
213T
215T
254T
1/2"-13 x 1-3/4" 4
256T