Cobalt Digital COMPASS 9223 Dual-Channel 3G_HD_SD MPEG-4 Encoder User Manual
Page 24
24
9223-OM (V2.0)
o
Auto Detected: The encoder will auto-detect the input signal, and automatically
configure for it if it is a supported signal. The Input Resolution, Input Source,
and Field/Frame Rate controls are not displayed.
The following table lists the supported input video signals:
Composite Signals
SDI Signals
NTSC
NTSC 4.43
PAL B/D/G/H/I/N
PAL-M
PAL-Nc
SECAM
720×480i59.94
720×576i50
1280×720p50
1280×720p59.94
1280×720p60
1920×1080p23.98
1920×1080p24
1920×1080i50
1920×1080i59.94
1920×1080i60
1920×1080p50
1920×1080p59.94
1920×1080p60
If Video Input Settings is set to Manual Selection, the Input Resolution, Input Source and
Field/Frame Rate parameters are displayed and must be set to match the incoming video signal.
•
Input Resolution: Select the resolution of the input video signal. The following four
choices are available:
o
SD: 720×480i (this will be presented as 720×576i if Field/Frame Rate is set to
PAL).
o
HD: 1280×720p
o
HD: 1920×1080i
o
HD: 1920×1080p
•
Input Source: Select the input source type. This control is available only if the Input
Resolution is set to SD. In this case, the options will be Composite or SD-SDI. If
Input Resolution is set to any of the HD values, this control will not be selectable, and
will show the appropriate type of input (HD-SDI for 1280×720p and 1920×1080i, and
3G-SDI for 1920×1080p).