Cobalt Digital COMPASS 9223 Dual-Channel 3G_HD_SD MPEG-4 Encoder - Manual (Page 53)

53
9223-OM (V2.0)
No changes to Apply Configuration Changed
In general, most changes will cause the encoder channel to stop and start again, causing a brief
(2-second) interruption to the stream. Changes to the following parameters are implemented on-
the-fly, without stopping the encoder:
•
Audio Source in Basic Tab – Audio Configuration
•
Language Code in Basic Tab – Audio Configuration
•
Any CC/AFD configurations made.
•
Audio Gain L/R in Analog Audio Parameters
•
Audio Mute L/R in Analog Audio Parameters
•
Audio Type and Dolby PMT Type in PMT Information
•
Transport Stream ID in Advanced Tab – Mux Parameters
•
Enable SDT and all the SDT parameters in Advanced Tab – Mux Parameters
•
Any connections made in the ASI/IP Streaming selection
•
Secondary Audio PID changes in Encoder 1 when Secondary Audio is enabled.
Encoder Statistics Tab
The Encoder Statistics Tab is divided into four lower tabs, as indicated below:
The Basic, Advanced and Connections tabs are direct equivalents of their configuration
counterparts. They present the current value of each of the configuration parameters. When the
Apply/Cancel buttons are grayed out, the contents of these tabs exactly match their
configuration counterparts. When the Apply/Cancel buttons are active, configuration
parameters have been changed. The current (running) encoder configuration can still be
inspected in the statistics tabs, prior to clicking on the Apply button.