Cobalt Digital COMPASS 9223 Dual-Channel 3G_HD_SD MPEG-4 Encoder - Manual (Page 9)

9
9223-OM (V2.0)
Indicators and Switches
The 9223 card and its rear module is intended for installation only in 20-slot openGear
®
frames
such as the 20-slot DFR-8321 frame or the Cobalt 8321 frame. Prior to installing the card, first
install the corresponding rear panel I/O module.
Rear I/O Panel Indicators
The 9223 rear I/O panel is depicted below. It includes two software-configurable
Composite/SDI video inputs on standard BNC connectors, two ASI output ports on standard
BNC connectors, four unbalanced analog audio inputs on standard RCA connectors, and two
100/1000 Mb/s Ethernet ports on standard RJ-45 connectors.
Each of the video inputs has a green indicator LED, with the following states:
•
LED off: no video signal detected, or input not configured.
•
LED flashing: video input locked to the video signal.
o LED flashing about once per second: input video is SD.
o LED flashing about twice per second: input video is HD-SDI.
o LED flashing about 4 times per second: input video is 3G-SDI (1080p60).
Each of the ASI output ports has a green indicator LED, with the following states:
•
LED off: ASI output port is disabled.
•
LED flashing: ASI output port is configured and enabled.
Each of the Gigabit Ethernet ports has two indicator LEDs, with the following states:
•
Green LED:
o Off: No link
o On: Link
•
Yellow LED:
o Off: No activity (transmit and/or receive)
o Flashing: Port is currently transmitting and/or receiving