Cobalt Digital COMPASS 9223 Dual-Channel 3G_HD_SD MPEG-4 Encoder - Manual (Page 51)

51
9223-OM (V2.0)
The RTMP configurable parameters are:
•
RTMP Protocol: Select the protocol variant, as discussed above.
•
Primary Server: Enter the host name or IP address of the primary (or single) RTMP
server to be contacted. If you want to use host names instead of IP addresses, make sure
to configure at least one DNS server.
•
Backup Server: If you have a backup RTMP server, configure it here; otherwise, this
field can be left empty. The encoder will only attempt to contact the backup RTMP
server if it cannot establish a connection with the primary server.
•
Port Selection: If your RTMP server is using the default TCP ports for the protocol
variant, select Use Default. If your server is using a non-standard port, select Specific
Port. When Specific Port is selected, an additional field is displayed:
•
Port: This field is only displayed if Port Selection is set to Specific Port. Configure a
non-standard TCP port here.
•
Authentication: Some RTMP servers require username/password authentication for
access. If your server does not require authentication, select No, otherwise select Yes. If
you select Yes, additional fields are presented: