Net Optics iTap 10 GigaBit Port Aggregator - Manual (Page 14)

iTap 10 GigaBit Port Aggregator
10
To computer with
terminal emulation software
Management
Port RS232
Connect the CLI Interface
All configuration options, status, and statistics can be accessed using the device's
Command Line Interface (CLI). To use the CLI, connect a DB9 cable from the
RS232 port on the back of the iTap to your computer.
Your computer needs to have terminal emulation software such as HyperTerminal to
access the iTap CLI over the RS232 cable.
To connect the CLI:
1. Connect a PC with terminal emulation software, such as HyperTerminal, to the
iTap using the RS232 DB9 cable supplied with the iTap.
Figure 3: Connecting RS232 Cable to iTap
2. Launch terminal emulation software and set communication parameters to:
19200 baud
8 data bits
No parity
1 stop bit
No flow control