Net Optics iTap 10 GigaBit Port Aggregator - Manual (Page 23)

iTap 10 GigaBit Port Aggregator
19
Turn the Management Port Off and On
Check that the Management Port is functional by typing the iTap Port Aggregator
IP address in a Web browser. Net Optics Web Manager should display. If it
does not, check the Management Port cable connections and use the following
procedure to make sure the Management Port is ON.
To turn the Management Port off and on:
1. Enter show set 1 to view the current setting. Management Port should be ON.
Use Web Manager to verify that the Management Port is operational.
2. Enter set mgtport 2. The Management Port turns off.
3. Enter show set 1 to view the current setting. Management Port should be OFF.
Use Web Manager to verify that the Management Port is off; the browser cannot
refresh Web Manager because it cannot communicate with the iTap.
4. Enter set mgtport 1. The Management Port turns on.
5. Enter show set 1 to view the current setting. Management Port should be ON.
Use Web Manager to verify that the Management Port is operational.
Turn the Front Panel Display Off and On
To turn the front panel display off and on:
1. Enter show set 1 to view the current setting. Display should be ON. Look at the
display to verify that it is on; port utilization statistics should be visible.
2. Enter set display 2. The display turns off.
3. Enter show set 1 to view the current setting. Display should be OFF. Look at
the display to verify that port utilization statistics are not visible. The display
shows "Net Optics, Inc." and the firmware compile date in OFF mode.
4. Enter set display 1. The display turns on.
5. Enter show set 1 to view the current setting. Display should be ON. Look at the
display to verify that port utilization statistics are again visible.