Net Optics iTap 10 GigaBit Port Aggregator - Manual (Page 58)

iTap 10 GigaBit Port Aggregator
54
Command Sub-Command Syntax Description
Set
(continued)
Username set username
<username>
Where <username> is the
authorized user's name,
32 characters or less
Password set password
<password>
Where <password> is the
authorized user's password,
32 characters or less
Mgtport set mgtport
<parameter>
Where <parameter> is
1 = Managment Port on
2 = Management Port off
(other values not applicable)
Enable Port set enable port
<port ID>
<parameter>
Where <port ID> is 1 or 2
and <parameter> is
1 = Monitor Port Laser Enabled
2 = Monitor Port Laser Disabled
(other values not applicable)
Mode Port set mode port
<port ID>
<parameter>
Where <port ID> is 1 or 2
and <parameter> is
1 = Tap mode
2 = Aggregation mode
(other values not applicable)
Note 1: Both Monitor Ports
must always be set to the
same mode or the device
behavior will be undefined.
Note 2: When changing from
Tap to Aggregation mode,
you must change port 2
before you change port 1.
CRCregen Port set crcregen port
<port ID>
<parameter>
Where <port ID> is 1, or 2
and <parameter> is
1 = CRC regeneration on
2 = CRC regeneration off
(other values not applicable)
Note: CRC regeneration is
helpful to make sliced and
timestamped packets valid
Stamp Port set stamp port
<port ID>
<parameter>
Where <port ID> is A or B
and <parameter> is
1 = Timestamping on
2 = Timestamping off
(other values not applicable)