Net Optics iTap 10 GigaBit Port Aggregator - Manual (Page 18)

iTap 10 GigaBit Port Aggregator
14
Assign a New iTap Port Aggregator IP Address
Be sure that you have the correct new IP address for the iTap Port Aggregator
before you change the IP address value from the default 192.168.1.2.
To assign a new IP address to the iTap Port Aggregator:
1. Type set ip <new ip address>.
2. Press Enter.
Example: Enter set ip 192.168.1.3 to set the iTap Port Aggregator IP address to
192.168.1.3. Web Manager and System Manager can access the device at this
address. Use set manager <new ip address> to set the address for SNMP traps.
Change Port Utilization Threshold Levels
To change the port utilization threshold levels:
1. Enter set threshold port a <new level> to set a percentage of available band-
width for Port A. Utilization exceeding this limit will trigger an alarm.
Example: Enter set threshold port a 30 to set the alarm threshold level for
traffic received on Port A to 30%.
2. Repeat Step 1 for ports B, 1, and 2.
Set the Current Date and Time
To change the current date and time:
• Enter set time <mm/dd/yyyy-hh:mm:ss> where mm is month, dd is day of the
month, yyyy is year, hh is hour, mm is minutes, and ss is seconds.
Time is based on the 24‑hour clock. This clock is used to record the time of traffic
peak utilization events.