Asus RS260-E4/RX8 - Manual (Page 27)

ASUS RS260-E4/RX8 2-7
2.1.5 Installing the air duct
To install the air duct:
1. Take note of the parts of the air duct that should match specific locations
inside the chassis.
2. Position the air duct inside the
chassis aligning with the two air duct
screw holes.
3. Check the rubber pads underneath
the air duct and ensure that they are
in place; otherwise, the air duct will
not fit properly.
4. Fit the other end of the air duct
making sure that no power cable is
strayed under it.
Be careful not to pull off or break any cables while installing the air duct.
Flat rubber pad should match the top of the
two heatsinks
6. When the air duct is in place, arrange the power cable cluster to fit the space
beside the air duct.
air duct screw holes
5. Fasten the air duct with screws.
air duct screw holes