Asus RS260-E4/RX8 - Manual (Page 54)

Chapter 2: Hardware setup 2-34
2.7.4 Front panel LED and switch board
To uninstall the front panel and swtich board:
1. Disconnect all cables connected to the rear of the board.
2. Remove sticker on the front panel and unscrew the board to the chassis.
Front side Rear side
Locator switch connector (blue/white)
Panel connector
Front USB connector
Locator LED connector (red/black)
3. Carefully remove the board out of the chassis.
When removed, the LED and switch board appears as shown. The LEDs and
switches on the board correspond to the LEDs and buttons on the system front
panel.