Xylem CG 853P - Manual (Page 43)

Operation
119
4.4.2 Switching on AutoStore (Int 1)
The storage interval (Int 1) determines the time interval
between automatic storage processes.
After the time interval expires, the current data record is
transmitted to the data storage and to the interface.
The storage interval (Int 1) is set to OFF in the factory.
Thus, the
AutoStore function is switched off.
To switch the function on, set up a time interval (5 s, 10 s,
30 s, 1 min, 5 min, 10 min, 15 min, 30 min, 60 min).
Note
If the
AutoStore function is active, the setting of the data
transmission interval (int 2) is ineffective (see page 128).
1 Press and hold down the <run/enter> key.
2 Press the <STO> key. Int 1 appears on the display.
3 Press the < ▲ > < ▼ > keys to set up the required time
interval between storage processes.
4 Confirm with <run/enter>.
The number of free memory locations appears on the
display.
Setting the storage
interval