Xylem handylab OX 12 - Manual (Page 37)

handylab Ox 12 Operation
37 ba75369e04 01/2011
Outputting the
calibration
protocol on the
interface
Note
You will find a sample calibration protocol in P
RINTING THE CALIBRATION RE -
CORD , page 23.
3 Using <M> or <RUN/ENTER>, you can switch back to the measuring
mode.
1 Press the <RCL> key repeatedly until CAL appears on the display.
2 Press the <RUN/ENTER> key.
The calibration protocol is transmitted to the interface.
After the data transmission, the measuring instrument automatically
switches to the measuring mode.
d
ARng ConCal
Store Auto
0
No.
LoBat
Day.Month
Year Ident
UpH
AR
%
°F
°C TP
mV/pH
mol/L
TempError AutoCal DIN CalError
AutoCal TEC
Time Baud
1 S
mg/L
% ppm
ISE
L C A
r s e
RCL