Xylem handylab OX 12 - Manual (Page 45)

handylab Ox 12 Operation
45 ba75369e04 01/2011
4.7 Reset
You can reset (initialize) the measurement parameters and the configuration
parameters separately from one another.
Measurement
parameters
The following measured parameters (O
2
InI) are reset to the default condi-
tion:
Note
The calibration data gets lost when the measuring parameters are reset.
Recalibrate after performing a reset.
Configuration
parameters
The following configuration parameters (InI) are reset to the delivery status:
Measuring mode D. O. concentration
AutoRange automatic measure-
ment range selection On (YES)
Relative slope 1.00
Correction factor of the relative
slope 1.000
Salinity equivalent 0.0
Salt content correction off
Baud rate 4800
Interval 1
(automatic save)
OFF
Interval 2
(for data transmission)
OFF