Xylem SDI-12 Data Logger iLink - Manual (Page 37)

i Quest (NZ) Ltd - PO Box 15169 HAMILTON Tel: +64 7 957 8160 - Fax: +64 7 957 8162 - Email:
iLink - Configuration and Support Utility 37
[email protected]
6.3 DS-4483 Configuration
[Configuration][DS-4483 Logger]
This section deals with configuring Templates for the DS-4483. Templates are used to manage the
sensor and I/O configurations loaded into the device. Connection settings such as baud rate, dial-up
telephone number, modem configuration etc are contained in the profile for the device
When creating and configuring new sensors for a device it is recommended that you begin by following
the New Sensor Wizard. You can then check and modify any settings as appropriate by referring to the
following configuration guide.
Selecting [Configuration] [DS-4483] from the menu opens the template configuration window. If the device
is attached to an existing template, the following will be displayed:
Select
[Yes] to load the template into iLink or select [No] to load a ‘blank’ template.
The template configuration dialog will then be displayed.