Xylem SDI-12 Data Logger iLink - Manual (Page 68)

68 iLink - Configuration and Support Utility
iQuest (NZ) Ltd - PO Box 15169 HAMILTON Tel: +64 7 957 8160 - Fax: +64 7 957 8162 - Email: [email protected]
Clear the Unload Log
[Clear Log]
While iLink is running in Auto Unload Mode it generates a log file detailing information such as the time of
each unload, the device unloaded etc. This file is stored in the root iLink folder and can be viewed in the
Auto Unload Scripting Control window. If the log becomes unmanageably large, it can be cleared by
clicking this button. Both the disk file and log window will be cleared.
Manually Running an Unload Schedule
It is possible to run any unload schedule directly by clicking on the checkbox next to its entry in the script
pane. In the screenshot above, an unload schedule has been set up for a DS-4483 logger using a profile
named 4483.prf. This unload has been activated manually by checking the box and the resulting log file
can be seen in the log file pane. The Unload Settings for this profile enables the Auto-Sync After Unload
and this can be seen in the log file (RTC synchronised in device).
Note also, that if you are viewing the Script Control window while an automatic unload occurs, you will see
a check appear next to the appropriate entry for the duration of the unload