Xylem SDI-12 Data Logger iLink - Manual (Page 61)

i Quest (NZ) Ltd - PO Box 15169 HAMILTON Tel: +64 7 957 8160 - Fax: +64 7 957 8162 - Email:
iLink - Configuration and Support Utility 61
[email protected]
8 DEVICE CALIBRATION
8.1 Device Calibration
[Configuration] [Calibration/Personality]
This option is only available when iLink is connected to a device that supports Calibration Configuration,
such as the DS-4483 logger. It can be used to modify some of the parameters needed by the device
firmware, and to view internal manufacturing/hardware properties of the device, such as the device Serial
Number, Date of Manufacture, Firmware Version etc.
The primary use of this configuration feature is to specify the operating mode of the Internal modem. The
other settings are provided as diagnostic tools and it should not normally be necessary to alter these.
When the Calibration Configuration is selected, iLink attempts to communicate with the connected device
and retrieve the calibration table. If successful, the following message will appear:
Clicking on [
OK ] will bring up the calibration dialog.
Manufacturing Details
These are configured at the time of manufacture and cannot be altered.
Internal Modem Mode
{Radio/Leased Line, PSTN/Cellphone}
Select the mode in which the internal modem should operate. This will naturally depend on the method of
communication.