Xylem SDI-12 Data Logger iLink - Manual (Page 5)

i Quest (NZ) Ltd - PO Box 15169 HAMILTON Tel: +64 7 957 8160 - Fax: +64 7 957 8162 - Email:
iLink - Configuration and Support Utility 5
[email protected]
1 INSTALLATION and OVERVIEW
1.1 Introduction
Thank you for purchasing
iLink. iLink is a utility program used for communicating with the range of System
DO ® products manufactured by iQuest (NZ) Ltd. This program is used for:
Configuring the device
Setting the device’s address
Loading firmware
Loading application programs
Writing/editing application programs
Downloading logged data
Viewing logged data
Hardware and software diagnostics
The range of options available to the User will vary from device to device.
1.1.1 Supported System DO
®
Products
System DO
® products supported include:
DS-CPU3 Controller
DS-4483 Datalogger
DS-12840i
Remote Telemetry Unit
IRIS 300 GPRS Equipped Datalogger
1.1.2 Unsupported System DO ® Products
The following System DO
® products not supported by iLink are:
DS-CPU2 DO Station
DS-IRM Intelligent Radio Modem
DS-CP/I Communications Protocol Interface
DS-8840i Remote Telemetry Unit
DS-RTU Remote Telemetry Unit
DS-PS1 Pico Station
For these legacy or specialist products, use the DOS support tool, Manage.