Xylem SDI-12 Data Logger iLink - Manual (Page 50)

50 iLink - Configuration and Support Utility
iQuest (NZ) Ltd - PO Box 15169 HAMILTON Tel: +64 7 957 8160 - Fax: +64 7 957 8162 - Email: [email protected]
6.3.4 New Sensor Wizard
The New Sensor Wizard is the recommended method of adding new sensors to a device template. It will
take the user through a number of simple steps and then create the sensor using the supplied information
and any necessary defaults. The sensor configuration can then be reviewed and, if necessary,
customised as appropriate. The stages of the wizard are outlined below.
Starting the New Sensor Wizard
Open the DS-4483 Configuration Window [Configuration][DS-4483 Logger]
1. Select an empty sensor location (or [
Clear ] an existing sensor location.). In the screenshot above,
sensor location number 04 has been selected by clicking on the ‘04’ in the Sensor Selection window.
2. Click on [New Sensor Wizard]
The wizard will launch and you will be asked to confirm that you wish to begin the wizard.
3. Click
[Next] to continue.
At any stage of the wizard you can click [Back] to review/change your settings or
click [Cancel] to exit the wizard.