Xylem WQL-pH pH DATALOGGERS - Manual (Page 40)

Logging WQL-pH
114 ba75821e01 10/2009
7 Logging
Listed below are the typical operating steps with which to set up and carry out
a logging job. The chapters where the operating steps are described in detail
are also mentioned.
7.1 Typical sequence of a logging job (checklist)
1 Connect the logger to the PC with the USB cable.
2 Start the WQL-Log program (see section 3.5 S TARTING THE WQL-L OG
PROGRAM ).
3 Register the logger (see section C ONNECTION TO LOGGER ).
4 If there are measured values in the logger, read them in (see
chapter 7.5 R
EADING IN DATA ).
5 Clear the logger memory (see section 7.6 O VERVIEW OF THE DATA
WINDOW ).
6 Calibrate the logger with the electrode (see chapter 5 C ALIBRATING
FOR P H MEASUREMENTS ).
7 Set up the logging job and send it (see section 7.3 S ETTING THE
PARAMETERS AND STARTING THE LOGGING JOB ).
8 Disconnect the USB cable from the logger.
9 If necessary, start the logger with the key button.
10 Check the operation of the logger based on the behavior of the signal
LED (see section 7.4 S
IGNAL LED TO INDICATE THE OPERATING
CONDITIONS OF THE LOGGER ).
11 Tightly close the logger with the cap.
12 Install the logger at the measuring location.
13 After completion of the logging job: Connect the logger to the PC with
the USB cable (see step 1 etc.).