Xylem MULTI 3400 MULTI-PARAMETER METERS - Manual (Page 46)

Operation Multi 3400i
46
4.6.3 Outputting the data storage
You can output the contents of the data storage:
z Stored data on the display
z Calibration data on the display
z Stored data on the serial interface
z Calibration protocol to the interface
Outputting stored data
on the display
You can perform the following activities:
1 Press the <RCL> key repeatedly until StO dISP appears on the
display.
2 Press the <RUN/ENTER> key.
A measured value appears on the display.
The storage location of the data record is displayed for approx.
2 s, then the respective temperature appears.
Display further data of the data record
(ID number, date, time, storage location) Press <RUN/ENTER>
To toggle between two saved measured vari-
ables Press <RUN/ENTER>
+ <M>
Advance one data record (storage location) Press <
▲>
Go back one data record (storage location) Press <
▼>
Store Auto
Ident
S
1
LoBat
Tref25
nLF
/ K %
Sal
°
AR
TP
C
M
m
% mg/l
cm
S/ cm
cm 1/
° F
ARng Cal Lin
Tref20
Sal TDS
mbar
O UpH
mV/pH
AutoCal DIN
AutoCal TEC
Time Baud
Day.Month No.
Year
p
S T O
d I s
RCL
ARng
No.
Store Auto
% / K
Sal 1/cm
° F
8
%
mV/pH
m S/
cm
cm M
Sal
LoBat
Time Baud
Day.Month
Ident Year
mbar
1
S
AR Cal
TDS UpH
Lin
Tref25 Tref20
nLF
AutoCal DIN
AutoCal TEC
0 3 6
O
mg/l
RCL
TP
° C
5 2 0