ABUS FU9001 Privest Wireless Alarm Base Set Operating instructions - Manual (Page 25)

21
3.2 Deactivating/Disarming the ABUS wireless alarm system
When you deactivate the ABUS wireless alarm system, the system sensors are disarmed.
The triggering of a sensor no longer results in an alarm.
Exceptions: Smoke detectors, sensors you have defined as door chimes, and all detectors
integrated in zones that are monitored 24 hours a day. For detailed information about
detectors that can also trigger when deactivated, refer to the installation manual. This
chapter tells you the different ways of deactivating the ABUS wireless alarm system.
If defined, deactivation is confirmed by a local announcement.
IMPORTANT:
If you enter the wrong PIN during deactivation, the operating panel emits 3 brief tone
signals. You hear the voice message “Fail to disarm. Wrong Code. Please try agan.”
You can deactivate 2 different elements. You can:
-
deactivate the complete system
- deactivate partitions
In addition to entering the user PIN and pressing the control buttons, there are two other
ways of deactivating the system:
-
deactivation under duress (silent alarm)
- silencing an alarm
3.2.1 Disarming the system
Geben Sie Ihren Benutzer PIN ein und drücken Sie die Taste. All partitions
assigned to this PIN are now deactivated.
IMPORTANT:
If your are outside your home and the ABUS wireless alarm system is activated, enter
your home only via the zone to which you have assigned the property “entry and exit
delay” (see section 1.1). This is usually your entrance door. When this zone triggers, no
alarm is set off at first – only the operating panel begins to beep. This informs you that
entry delay time countdown has started. You also hear the following message: "System
in disarm process. Please enter your code.” Before the entry delay time expires, you
have to enter your user PIN and press . Otherwise, an alarm is triggered.