ABUS FU9001 Privest Wireless Alarm Base Set Operating instructions - Manual (Page 53)

49
9.2 Appendix B: Audible signals
In addition to the visible LED, your system generates audible tone signals following
specific events.
Event Tone signal
Intrusion alarm Fast continuous beeps
Fire alarm Fast, staggered beeps (see note 2)
Keypad police
emergency Fast beeps (see note 1)
Keypad fire emergency Fast, staggered beeps (see note 2)
Keypad med. care
emergency No audible signal
Arming/Disarming If performed correctly, a short audible signal sounds. If
arming is not possible, three fast beeps are heard (see
note 2).
Countdown of entry
delay period Slowly repeated tones until the entry delay countdown
expires (see note 2).
Countdown of exit
delay period Slowly repeated tones until the exit delay countdown
expires (see note 2).
Correct/incorrect input
of data or button
sequence If performed correctly, a short audible signal sounds. Three
fast beeps if the input is incorrect or the menu option
cannot be selected (see note 2).
Chime signal A two-second-long tone signal (see note 3)
NOTES:
1. In the installer menu, under System Control, you define whether a panic alarm
is silent – i.e., reported by telephone only – or whether it also generates a local
alarm.
2. The operating panel emits a beep during the countdown of the entry/exit delay.
Operating panel fire alarm, operating panel error and operating panel
confirmations are deactivated. These beeps can be deactivated at the user’s
request.
3. Any zone can be programmed with the property: door chime. If this zone is
opened during a deactivated state, this event is announced by the operating
panel (by a chime). The chime can be disabled.