ABUS FU9001 Privest Wireless Alarm Base Set Operating instructions - Manual (Page 34)

30
Chapter 5 User PINs
For many of the functions of the ABUS wireless alarm system, you need a security
code – your user PIN. These PINs are between 4 and 6 digits long. You can define up to
32 different user codes for the ABUS wireless alarm system.
You can also assign an authorisation level to each user PIN. Users with “higher”
authorisation have access to a larger number of system functions. Users with “lower”
authorisation are more restricted in the functions they can perform. When programming,
you can select between 8 different authorisation levels. For more information on defining
authorisation levels, see the installation instructions.
IMPORTANT:
Your ABUS wireless alarm system has the so-called Grand Master PIN 1-2-3-4 as a
factory default. If your installer has not yet changed this PIN according to your wishes,
you should now change it so that only you know it.
5.1 Entering/changing the user PIN
Only the user with the Grand Master PIN can change all user PINs. Users with lower
authorisation levels can only change their own PINs.
The system must be deactivated before user PINs can be entered or changed.
To enter/change a user PIN:
1. Press to enter “user functions” mode.
2. Press [5] followed by your user PIN.
3. Confirm with .
4. Press [1] for user PIN.
5. Press [1] for define/update.
6. Now enter a two-digit user index number. The user index number is the
number you assign to a user PIN.
For example: To assign the user index number 6 to a user PIN, press [0] and
[6].
IMPORTANT:
The system manages user index numbers 00 to 32, corresponding to the number of
possible users. User index number 00 is reserved for the Grand Master PIN.
IMPORTANT:
If you enter an invalid PIN, the operating panel emits three short beeps. The following
message is issued: “Wrong Code. Please try again.” In this case, press the
buttons repeatedly and enter the correct PIN.