ABUS FU9001 Privest Wireless Alarm Base Set Operating instructions - Manual (Page 43)

39
With the and buttons, you can enter all characters and digits you need
for your commands. With the and buttons, scroll to the desired position
and press the above buttons repeatedly until the character you want appears in the
second line of the LCD display.
You can enter the following characters and digits with these buttons:
You can enter: Stands for …
0 – 9 Corresponds to the numeric buttons (0 to 9)
#
Corresponds to .
¾
Corresponds to .
A,B,C Corresponds to a previously programmed
macro button
E
Stands for external activation
I
Stands for internal activation
6. After entering characters/digits, make sure that the cursor is placed after the
last character/digit. After completing your entries, press .
All characters/digits to the right of the cursor are ignored.
7. Now press your selected macro button and keep it pressed for 2 seconds. The
character/digit sequence is stored and assigned to the selected macro button.
8. To program further macro buttons, repeat the above steps.
To activate a programmed macro button:
1. Press the [1], [2] or [3] button and keep it pressed for 2 seconds to activate the
macro. You hear the following confirmation message: “[Makro X] activated”.???
2. If the macro button is not defined, you hear the message: “Makro not defined”.
IMPORTANT:
After entering characters/digits, make sure the cursor is placed after the last entered
character/digit. You can do this with the button.
Another example of entering a macro to access the installer menu: [*] [9] [1] [0] [1] [3] [3]
[#] (the installer PIN here is 0133)