ABUS FU9001 Privest Wireless Alarm Base Set Operating instructions - Manual (Page 29)

25
4.2 Operation menu
You can operate the ABUS wireless alarm system by pushbutton telephone from the
operation menu. Voice messages tell you what setting options you have and how to
perform the corresponding function. Your options in the operation menu vary according
to your access rights and the state of your system.
For example: If all partitions of your system are activated, the system arm option is no
longer announced.
IMPORTANT:
To hear a voice message again, press [#]. You do not have to wait for the end of a
voice message. If you know the right key combination, you can press it at any time to
select a setting or function.
If you do not know the exact key combination, you can follow the spoken instructions of
the system.
This table shows the settings you can make by telephone to the ABUS wireless alarm
system and the key combinations you need:
Setting/function Combination of telephone keys
Activate / Arm all partitions [1][1]
Activate / Arm selected partitions
Example: Activate partition 2 [1][9] [Partition No.]
[1][9] [2]
Deactivate/ Disarm all partitions [2][2]
Deactivate / Disarm selected partitions
Example: Deactivate partition 2 [2][9] [Partition No.]
[2][9] [2]
Reintegrate omitted zones [3][Zone No.][#][9]
Control switch / utility outputs [4][Switch output No.]
Change Follow Me (FM) telephone
numbers [5][FM No.][#][2]
Listen in to object [6][1]
Speak to object [6][2]
Play message [7][1]
Record message [7][2]
Exit system [0]
Return to previous menu [*]
Repeat menu options [#]
Activation:
If you activate by telephone, note that it is possible that one partition will remain
unsecured if it contains open zones.
Omit zones:
Omitting a zone (see section 1.1) causes the detector to which this zone belongs to
remain unsecured. The zone is automatically reintegrated following deactivation.
The “omit zone” option can be completely disabled. However, it is then no longer
available in the operation menu.