ABUS FU9001 Privest Wireless Alarm Base Set Operating instructions - Manual (Page 27)

23
Deactivation with a duress PIN:
Deactivation with a duress PIN is similar to normal deactivation. The only
difference: Instead of your user PIN, enter the duress PIN before pressing .
All partitions assigned to this PIN are deactivated AND a silent alarm is transmitted
to the emergency command centre.
3.2.4 Silencing an alarm
After the ABUS wireless alarm system triggers an alarm, it is in alarm memory mode.
When you silence the alarm, the system switches back to deactivated status.
1. The ACTIVE LED shows you whether an alarm has been triggered in your
system. If this LED is flashing and the LCD display shows the triggered zone,
there was an alarm.
2. To silence the alarm: Enter your user PIN and press . The following
message is played: “System / [partition X] disarmed, Alarm occured in the
system, check display!“
The ACTIVE LED flashes and the operating panel displays the alarm zone for
about 60 seconds.
IMPORTANT:
Leave the building as soon as you notice that your system has triggered an alarm. Not
until after the security personnel have completed their investigations can you be sure
that the building is free of intruders.
In particular cases, if this is programmed, you need the technician’s code to activate the
system following an alarm. The LED display then shows the message “Not ready –
technician reset”.