ABUS FU9001 Privest Wireless Alarm Base Set Operating instructions - Manual (Page 26)

22
3.2.2 Disarming partitions
1. Select the partition you want to deactivate. Do this by pressing and
entering the partition number [1/2/3].
2. Enter your user PIN and press . You hear the following announcement:
“{System / [partition x]} disarmed”.
3. Repeat these steps to deactivate further partitions.
Example:
To deactivate partition 3 with user PIN 1-2-3-4, press the following:
3 1-2-3-4
IMPORTANT:
If the ACTIVE LED flashes following deactivation, check the display for activated
(alarmed) zones.
3.2.3 Disarming under duress / silent alarm
With the ABUS wireless alarm system, you can deactivate the system with a forced
code. If you enter the duress PIN, your alarm system is deactivated as normal, but
simultaneously a silent alarm is triggered. This alarm is transmitted to an emergency
command centre and must therefore never be triggered arbitrarily or accidentally. The
duress PIN is used if you are forced by someone else to deactivate the system.
To use the duress PIN, just add 1 to the last digit of your user PIN (see the examples in
the following table).
User PIN Duress PIN
1-2-3-4 1-2-3-5
5-6-7-8 5-6-7-9
6-7-8-9 6-7-8-0
IMPORTANT:
Never perform a forced deactivation with the duress PIN arbitrarily or for no special
reason. Emergency command centres take this very seriously and act fast!