Alpha Technologies Cordex CXPS-D 48-2500_5000A - Manual (Page 52)

-5HY% 
)LJXUH ² ,QVXODWLRQFRYHU UHDUYLHZ 
Cut between the holes
with side cutters to make a
large enough entryway for
the required cables. Figure
41 shows a small hole cut
in the cover.
Make a straight cut to the
back edge of the cover,
so the cover can be fitted
around the cables when
replacing it at the end of the
installation.
Reinstall the top cover.
6.8.3 Top Cover(s)
6.8.2 Installing the battery cable insulation covers
Insulation cover kits are included with the initial shipment of the equipment—two kits for each bay.
STEP 1
1. Start from the rear left and wrap an insulating cover around the cables and bus bar (Refer to Figure 41 and
Figure 42).
2. Secure with the plastic pins.
)LJXUH ² 7RS.\GH[FRYHUZLWKFXWVIRUFDEOHHQWU\