Atec Tektronix-1502 - Manual (Page 12)

TM 9-4935-601-14-3&P
Table 1-2. (cont)
ELECTRICAL CHARACTERISTICS
Characteristics Performance Requirements Supplemental Information
FEET/DIV Control
At X.1 Multiplier
Range
To 20 feet/div
To 5 metres/div for metric
Scales .1 feet/div to 20 feet/div 8 steps, 1-2-5 sequence
0.025 m/div to 5 m/div for metric 8 steps, 1-2.5-5 sequence
At X1 Multiplier
Range
To 200 feet/div DISTANCE dial disabled in
To 50 metres/div for metric 200 (FIND) position
Scales 1 foot/div to 200 feet/div 8 steps, 1-2-5 sequence
0.25 m/div to 50 m/div for metric 8 steps, 1-2-5 sequence
Dielectric Scales SOLID PTFE, V
p
/V
air
, = 0.70
r
= 2.04
SOLID POLY, V
p
/V
air
= 0.66
r
= 2.31
OTHER-VAR, V
p
/V
air
, = 0.55 to 1 VAR is calibrated for air
when turned to full cw
position. All buttons re-
leased causes default mode
and is cal. for air
Accuracy Within ±2%
External Recorder Inter-
face for X-Y Recorders
Horizontal
0.1 V/div Source impedance 10 k
Ω
Vertical 0.09 to 0.13 V/div (adjustable) Source impedance 10 k
Ω
Pen Lift
Mode 1
Source
V
s
= 5 V Nominal with R
s
= 10 k
Ω
Mode 2 (inverted
Mode 1)
Source
V
s
= 5 V Nominal with R
s
= 10 k
Ω
Y-T Plug-in Chart Recorder
Interface
Horizontal
0.4 V/div Source impedance 200
Ω
(switched)
Vertical 0.2 V/div Source impedance 200
Ω
(switched)
The TEKTRONIX Chart Recorder,
016-0506-03 is designed to operate
with the 1502. The chart uses
a heat sensitive stylus to
record on 4 cm chart paper.
Chart recording length is con-
trolled by the 1502.
REV D JAN 1981
1-3