Atec Tektronix-1502 - Manual (Page 6)

TM 9-4935-601-14-3&P
OPERATORS SAFETY SUMMARY
The general safety information in this part of the summary is for both operating and servicing personnel.
Specific warnings and cautions will be found throughout the manual where they apply, but may not appear in
this summary.
TERMS
In This Manual
CAUTION statements identify conditions or practices that could result in damage to the equipment or other
property.
WARNING statements identify conditions or practices that could result in personal injury or loss of life.
As Marked on Equipment
CAUTION indicates a personal injury hazard not immediately accessible as one reads the marking, or a hazard
to property including the equipment itself.
DANGER indicates a personal injury hazard immediately accessible as one reads the marking.
SYMBOLS
In This Manual
This symbol indicates where applicable cautionary or other information is to be found.
As Marked on Equipment
DANGER - High voltage.
Protective ground (earth) terminal.
ATTENTION - refer to manual.
Power Source
This product is intended to operate from a power source that will not apply more than 250 volts rms between
the supply conductors or between either supply conductor and ground. A protective ground connection by way
of the grounding conductor in the power cord is essential for safe operation.
Grounding the Product
This product is grounded through the grounding conductor of the power cord. To avoid electrical shock, plug
the power cord into a properly wired receptacle before connecting to the product input or output terminals. A
protective ground connection by way of the grounding conductor in the power cord is essential for safe
operation.
Danger Arising From Loss of Ground
Upon loss of the protective-ground connection, all accessible conductive parts (including knobs and controls
that may appear to be insulating) can render an electric shock.
Use the Proper Power Cord
Use only the power cord and connector specified for your product.
Use only a power cord that is in good condition.
Refer cord and connector changes to qualified service personnel.
Use the Proper Fuse
To avoid fire hazard, use only the fuse of correct type, voltage rating and current rating as specified in the parts
list for your product.
Refer fuse replacement to qualified service personnel.
Do Not Operate in Explosive Atmospheres
To avoid explosion, do not operate this product in an explosive atmosphere unless it has been specifically
certified for such operation.
Do Not Remove Covers or Panels
To avoid personal injury, do not remove the product covers or panels. Do not operate the product without the
covers and panels properly installed.
iv