Atec Tektronix-1502 - Manual (Page 24)

TM 9-4935-601-14-3&P
Figure 2-10. Crimped Cable. Figure 2-11. Frayed Cable.
An X-Y recorder can be used with the 1502 by connecting it to the X-Y OUTPUT MODULE when this
module is plugged into the 1502. Connect the X, Y, and PEN LIFT inputs of the recorder to the corresponding
jacks of the X-Y OUTPUT MODULE. See the information or manual provided with the recorder for further
information on its use.
Figure 2-12. X-Y Output Module Strap.
Mesh Filter for the crt
A mesh filter is provided with the 1502, which makes viewing of the crt easier when the unit is being used
in the sunlight. This filter is placed over the crt by sliding it onto the slots of the crt bezel.
Viewing Hood
The viewing hood provides shading for the crt and can be installed over the crt by sliding it down over the
crt bezel sides. The mesh filter must be removed before the viewing hood will connect it to the crt bezel.
Using a Camera with the 1502
If a Camera Adapter (Tektronix Part Number 016-0327-01) is attached to the crt bezel of the 1502, A C-
30B/31B camera can be used to take photographs of the crt display.
REV C FEB 1980
2-9