MoTeC M8 - Manual (Page 12)

10 MoTeC Software
Software Installation
The MoTeC Software must be installed on to the PC hard disk.
To install the software place the MoTeC Software Disk into the floppy disk
drive.
From the DOS prompt type A:INSTALL then press Enter. The software will
be automatically installed onto the hard disk.
A separate directory is automatically created for each version of the software.
Old versions are kept so that they may be used if necessary.
Do not change the MoTeC directory structure or move the software to a
different directory, otherwise the software will not operate correctly.
Starting the Software
Start the MoTeC Software from the DOS prompt [ C:\ ] by typing MOTEC then
press Enter, this will start the MoTeC Program Integrator.
If the software doesn’t start it may be necessary to change to the MOTEC
directory first by typing CD \MOTEC then press Enter.
The MoTeC Program Integrator lists all the available software programs. To
start the required program select it from the menu using the up and down
arrow keys then press Enter.
To exit the MoTeC Program Integrator and return to DOS, hold down the Alt
key then press X.
If using a monochrome screen press the F9 key to change the screen
colours between colour and black and white.
When using Windows 95 it is best to run the software in a full screen
rather than a window. (Press Alt and Enter)
Software Versions
The software will only work with an ECU that is the same type (M4, M48 or
M8) and is running the matching software version.
If multiple versions of the software are installed on the PC a list of the
available ECU types and versions will be displayed when the MoTeC Program
Integrator is started. The appropriate ECU type and version may then be